F 150 2WD V8-4.6L VIN W (2007)
Removal and Installation
1. Remove the 7 pin-type retainers and the radiator upper sight shield.
2. NOTE: Mark the location of the hood latch with a permanent type marker.
Remove the 2 hood latch bolts and position the hood latch aside.
-
To install, tighten to 12 Nm (9 lb-ft).
3. Disconnect the secondary hood latch release cable.
4. Disconnect the primary hood latch release cable.
5. Remove the secondary hood latch release screw.
-
To install, tighten to 8 Nm (71 lb-in).
6. Remove the secondary hood latch release.
7. To install, reverse the removal procedure.
-
When the hood latch is installed, the latch adjustment must be checked to make sure the latch is installed and aligned correctly.
-
Lubricate the hood latch after installation.