F 150 2WD V8-4.6L VIN W (2007)
WARNING:
-
The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when
handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so
could result in pretensioner or air bag deployment and could result in personal injury.
-
To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
-
If a seat equipped with a supplemental restraints system (SRS) component is being serviced, SRS must be depowered.
-
The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Driver seat shown, passenger seat similar.
All seats
1. Remove the front seat and depower the SRS.
2. Remove the front seat backrest.
3. Push the 2 release tabs and remove the head restraint.
4. Remove the safety belt tower cover.
-
Remove the 2 covers, 4 screws and the safety belt tower cover.
5. Remove the screw and separate the safety belt guide.
6. Lift the material and release the backrest J-clip.
