F 150 2WD V8-4.6L VIN W (2007)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor Front, Rear Wheel Drive (RWD)
Wheel Speed Sensor Front, Rear Wheel Drive (RWD)
Removal and Installation
1. Disconnect the battery ground cable.
2. With the vehicle in NEUTRAL, position it on a hoist.
3. NOTE: The harness connector is located in the engine compartment secured to the fender apron.
Disconnect the wheel speed sensor electrical connector.
4. Disconnect the 2 wheel speed sensor harness retainers from the brake hose.
5. Remove the wheel speed sensor harness from the pushpin retainer.
6. Remove the bolt and the wheel speed sensor.
^
To install, tighten to 8 Nm (71 inch lbs.).
7. To install, reverse the removal procedure.
