F 150 2WD V8-4.6L VIN W (2007)
Disc Brake System - Exploded View
Removal
WARNING: Use of any other than approved DOT 3 motor vehicle brake fluid will cause permanent damage to brake components and will
render the brakes inoperative. Failure to follow these instructions may result in personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety
Data Sheet (MSDS) if available. Failure to follow these instructions may result in personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with
water.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the brake caliper flow bolt and discard the 2 copper washers.
3. Remove the 2 guide pin bolts and the brake caliper.
Installation
1. Position the brake caliper and install the 2 guide pin bolts.
^
Tighten to 30 Nm (22 ft. lbs.).
2. Using 2 new copper washers, position the brake hose on the brake caliper and install the flow bolt.
^
Tighten to 35 Nm (26 ft. lbs.).
3. Bleed the brake system. See: Brake Bleeding