F 150 2WD V8-4.6L VIN W (2007)
Electronic Brake Control Module: Service and Repair
REMOVAL AND INSTALLATION
Anti-Lock Brake System (ABS) Module
Removal and Installation
CAUTION: Electronic modules are sensitive to electrical charges. The anti-lock brake system (ABS) module can be damaged if exposed to the
charges.
CAUTION: When installing a new ABS module or hydraulic control unit (HCU), do not use the pump motor harness as a carrying handle. Failure to
follow these instructions may result in damage to the HCU assembly.
All vehicles
1. Disconnect the battery ground cable.
Vehicles equipped with 5.4L engine.
2. Remove the air cleaner intake pipe.
All vehicles
3. Disconnect the ABS module electrical connector.
4. Remove the 4 screws and the ABS module.
^
To install, tighten to 3 Nm (27 inch lbs.).
5. NOTE: The ABS module is not repairable. If an internal problem exists, a new part must be installed.
