F 150 2WD V8-4.6L VIN W (2007)
4. Disconnect the vacuum tube connector.
5. Remove the bolt and position the transmission fluid level indicator tube aside.
6. Disconnect the engine wiring harness retainers from the valve cover stud bolts.
7. Remove the nuts and position the suction accumulator aside.
8. CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools
cause scratches and gouges which make leak paths. Use a plastic scraping tool to remove all traces of old sealant.
Remove the 11 fasteners and remove the RH valve cover.
^
Clean the valve cover mating surface of the cylinder head with silicone gasket remover and metal surface prep. Follow the directions on the
packaging.
^
Discard the valve cover gasket. Clean the valve cover gasket groove with soap and water or a suitable solvent.
