F 150 2WD V8-4.6L VIN W (2007)
Installation
1. Apply instant gel adhesive completely around the gasket groove in the valve cover and install the new valve cover gasket.
2. NOTE: If the valve cover is not secured within 4 minutes, the sealant must be removed and the sealing area cleaned with silicone gasket remover
and metal surface prep. Follow the directions on the packaging. Allow to dry until there is no sign of wetness, or 4 minutes, whichever is longer.
Failure to follow this procedure can cause future oil leakage.
Apply the silicone gasket and sealant in 2 places where the engine front cover meets the cylinder head.
3. Position the valve cover and install the fasteners in the sequence shown to 10 Nm (89 inch lbs.).
