F 150 2WD V8-4.6L VIN W (2007)
Evaporative Canister Filter: Service and Repair
DUST SEPARATOR
Removal and Installation
WARNING:
-
The evaporative emissions system contains fuel vapor and condensed fuel vapor. Although not present in large quantities, it still presents
the danger of explosion or fire. Disconnect the battery ground cable from the battery to minimize the possibility of an electrical spark
occurring, possibly causing a fire or explosion if fuel vapor or liquid fuel are present in the area. Failure to follow these instructions can
result in personal injury.
-
Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related component. Highly flammable
mixtures are always present and may be ignited. Failure to follow these instructions may result in personal injury.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery ground cable.
3. NOTE: The evaporative emission (EVAP) canister assembly is located above the spare tire.
Remove the spare tire.
4. Disconnect the fuel vapor tube quick connect coupling.
5. Disconnect the fuel vapor hose.
6. Remove the 2 front EVAP canister assembly bracket bolts.
-
To install, tighten to 13 Nm (10 lb-ft).
