F 150 2WD V8-4.6L VIN W (2007)
Exploded View
Removal and Installation
WARNING:
-
Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related components. Highly
flammable mixtures are always present and can be ignited. Failure to follow these instructions can result in personal injury.
-
Fuel in the fuel system remains under high pressure even when the engine is not running. Before working on or disconnecting any of the
fuel tubes or fuel system components, the fuel system pressure must be relieved. Failure to follow these instructions can result in personal
injury.
1. Disconnect the fuel hose spring lock coupling. Release the fuel system pressure.
2. Disconnect the battery ground cable.
3. Remove the air cleaner outlet pipe.
4. Remove the exhaust gas recirculation (EGR) system module tube.
-
To install, tighten to 40 Nm (30 lb-ft).
5. Disconnect the EGR system module electrical connector.
6. Disconnect the quick connect couplings and remove the positive crankcase ventilation (PCV) tube.
7. Disconnect the electronic throttle control electrical connector.
8. Disconnect the fuel rail pressure and temperature sensor electrical connector.
9. Disconnect the fuel rail pressure and temperature sensor vacuum connector.
10. Disconnect the 8 fuel injector electrical connectors.
