F 150 2WD V8-4.6L VIN W (2007)
Part 2
Exploded View
Removal and Installation
WARNING:
-
Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related component. Highly flammable
mixtures are always present and can be ignited. Failure to follow these instructions may result in personal injury.
-
Fuel in the fuel system remains under high pressure even when the engine is not running. Before servicing or disconnecting any of the fuel
lines or fuel system components, the fuel system pressure must be relieved to prevent accidental spraying of fuel, causing a fire hazard.
Failure to follow these instructions may result in personal injury.
CAUTION:
-
Fuel injection equipment is manufactured to very precise tolerances and fine clearances. It is therefore essential that absolute cleanliness
is observed when working with these components. Always install blanking plugs to any open orifices or tubes.
-
When reusing liquid or vapor tube connectors, make sure to use compressed air to remove any foreign material from the connector
retaining clip area before separating from the tube.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Release the fuel system pressure.
3. Disconnect the battery ground cable.
4. Disconnect the fuel filter outlet fuel tube spring lock coupling.
5. Disconnect the fuel filter bracket outlet vapor tube spring lock coupling.
6. Disconnect the fuel rail spring lock coupling.
7. Disconnect the evaporative emission (EVAP) canister purge valve vapor tube quick connect coupling.
8. Release the vapor and fuel tubes from the support bracket.
9. Remove the fuel tube assembly support bracket nut.
-
To install, tighten to 25 Nm (18 lb-ft).
10. Remove the fuel tube assembly support bracket and remove the fuel and vapor tube assembly.
11. To install, reverse the removal procedure.
-
If a tie strap was removed, reinstall a new tie strap in the same location.
