F 150 2WD V8-4.6L VIN W (2007)
3. NOTE:
-
One fuel level sensor wire routes behind the fuel level sensor and one routes along the left side of the fuel level sensor.
-
The grounding eyelet must be on the front side of the fuel level sensor.
Hook the fuel level sensor on the fuel pump module and install the screw through the grounding eyelet and tighten the screw. Clip the wire into the
clip on the fuel pump module.
All vehicles
4. Slide the heat shrink tube onto the wire harness and connect the electrical connector.
5. WARNING: Do not use an open flame to heat the heat shrink tube, use a heat gun only. Failure to follow these instructions may result in
personal injury.
Using a heat gun, heat the heat shrink tube.
