F 150 2WD V8-4.6L VIN W (2007)
Ground Distribution
Power and Ground Distribution Diagrams contains the diagrams that shows the complete details for each ground connection or main ground splice.
This is useful in diagnosing a problem affecting several components at once (poor ground connection or ground splice). All details (wires, splices,
connectors) between the ground point and the component are shown. These ground connection details are shown here in order to keep the individual
set of diagrams as uncluttered as possible.
C904
Component and Connector Information
Connector Views show the views of the pins and/or cavities of all connectors. The pin and cavity sides are shown separately as if the connector were
disconnected. The color of the connector housing is indicated next to the connector number when available. The harness causal number is located
above the connector view and below the connector number. The circuit function charts are located below each connector. The wiring harness
designations are listed in set Component Location Charts.
Component Location Views shows the components and their connecting wires as they can be found on the vehicle.
Location information that can be found at the vehicle level will helps the user find where the various items depicted on the diagram can physically be
found on the vehicle. A brief written description of the location is given, along with a reference to the component location views.
WARNINGS
-
Always wear safety glasses for eye protection.
-
Use safety stands whenever a procedure requires being under a vehicle.
-
Be sure that the IGNITION SWITCH is always in the OFF position, unless otherwise required by the procedure.
-
Set the parking brake when working on any vehicle. An automatic transmission should be in PARK. A manual transmission should be in
NEUTRAL.
-
Operate the engine only in a well-ventilated area to avoid danger of carbon monoxide.
-
Keep away from moving parts, especially the fan and belts, when the engine is running.
-
To prevent serious burns, avoid contact with hot metal parts such as the radiator, exhaust manifold, tail pipe,catalytic converter and muffler.
-
Do not allow flame or sparks near the battery. Gases are always present in and around the battery cell. An explosion could occur.
-
Do not smoke when working on a vehicle.
-
To avoid injury, always remove rings, watches, loose hanging jewelry and avoid wearing loose clothing.
Symbols
