F 150 2WD V8-4.6L VIN W (2007)
Fuel Pump Control Unit: Service and Repair
FUEL PUMP DRIVER MODULE (FPDM)
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery ground cable.
3. NOTE: The fuel pump driver module (FPDM) is located above the spare tire.
Disconnect the FPDM electrical connector.
4. Remove the FPDM bolts and the FPDM.
-
To install, tighten to 10 Nm (89 lb-in).
5. To install, reverse the removal procedure.
