F 150 2WD V8-4.6L VIN W (2007)
2. NOTE: Make sure the J-clips are in place before positioning the passenger air bag module to the instrument panel.
Position the passenger air bag module into the instrument panel.
1
Angle the rear of the passenger air bag module deployment door so the tabs engage to the instrument panel.
2
Position the passenger air bag module into place and push down on the deployment door, engaging the remaining tabs.
3. Install the RH defrost grille.
4. Install the 2 pin-type retainers that retain the passenger air bag module deployment door to the instrument panel (if equipped).
5. Install the passenger air bag module bolts.
-
To install, tighten to 9 Nm (80 lb-in).
6. Close the glove compartment.
7. Repower the system.
