F 150 2WD V8-4.6L VIN W (2007)
3. CAUTION: Putting the large RCM electrical connector into the RCM on an angle can cause bad electrical connections and damage
components.
NOTE: The RCM has been removed for clarity.
Position the large RCM electrical connector into the RCM.
-
CAUTION: Do not push the connector on to where the lever pivots and seats itself. Light pressure is needed to get the connector into
position on the RCM before using the lever to fully seat the connector.
With the large RCM electrical connector uniformly aligned to the RCM, lightly push in until a subtle audible click is heard and a slight
resistance is felt.
4. NOTE: The RCM has been removed for clarity.
Connect the large RCM electrical connector.
-
Using the connector position assurance lever, pivot it toward the RCM, drawing the connector into the RCM.
-
Make sure the thumb tab is engaged to the retainer on the RCM and locked in place.
5. Connect the restraints control module (RCM) small electrical connector.
6. If equipped, install the floor console.
7. If equipped, install the 20 percent front seat cushion. Align the retainers on the 20 percent seat cushion and press down firmly near the front of the
cushion to seat the retainers.
8. Repower the system.
