ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Seat Position Sensor > < Occupant Classification Sensor (OCS)|Page 6934
Page 6
background image

the air bag indicator will:
-

fail to light.

-

remain lit continuously.

-

flash.

The flashing might not occur until approximately 30 seconds after the ignition switch has been turned from the OFF to the ON position. This is the
time required for the restraints control module (RCM) to complete the testing of the SRS. If the air bag indicator is inoperative and a SRS fault
exists, a chime will sound in a pattern of 5 sets of 5 beeps. If this occurs, the air bag indicator and any SRS fault discovered must be diagnosed and
repaired.

Clear all continuous DTCs from the restraints control module using a scan tool.

13. NOTE:  A prepaid return postcard is provided with a new OCS service kit. The serial number for the new part and the vehicle identification

number (VIN) must be recorded and sent to Ford Motor Company.

When installing a new OCS service kit, fill out the necessary information on the OCS service kit traceability card and return it along with the
complete inoperative OCS system to Ford Motor Company.
-

When returning the inoperative OCS system, include the following: seat cushion foam pad, seat cushion frame, bladder, electronic control unit,
pressure sensor (transducer), hose, electrical connectors and wire harness.

Seat Position Sensor > < Occupant Classification Sensor (OCS)|Page 6934