F 150 2WD V8-4.6L VIN W (2007)
Removal and Installation
1. CAUTION: While repairing the power steering system, care should be taken to prevent the entry of contaminants or premature failure of the
power steering components can result.
With the vehicle in NEUTRAL, position it on a hoist.
2. NOTE: New O-ring seals must be installed any time the lines are disconnected from the steering gear.
Remove the power steering line clamp plate bolt, rotate the clamp plate and disconnect the return line.
^
Discard the O-ring seal.
^
To install, tighten to 23 Nm (17 ft. lbs.).
3. Release the clamp, disconnect the return line from the power steering fluid cooler and remove the line.
4. To install, reverse the removal procedure.
^
Fill the power steering system.
