F 150 2WD V8-4.6L VIN W (2007)
3. CAUTION: Do not use a large screwdriver. Apply minimum force during removal or damage to the sensor can occur.
Using a pocket screwdriver or similar tool, detach the sensor from the cradle.
4. Remove the sensor.
Assembly
1. CAUTION: Damage to the sensor can occur if excessive force is applied during sensor installation.
NOTE: Make sure the sensor is fully seated into the cradle. The sensor will make a "click" noise when correctly seated.
Position the sensor into the cradle by inserting the hinge end of the sensor into the hook end of the cradle and pushing the opposite end of the
sensor down onto the cradle.
2. NOTE: The locking clip can only be fully seated when installed in the correct orientation. If the sensor locking clip cannot be fully inserted, then
the sensor may not be fully seated on the cradle or the locking clip may be inserted backward.
Insert a new locking clip into the sensor.
