F 150 2WD V8-4.6L VIN W (2007)
4. Slide the driveshaft back enough to index-mark the driveshaft, the extension housing and the output shaft. Separate the driveshaft from the
transmission.
5. Using the special tools, remove the extension housing seal.
Installation
1. NOTE: When installing the new seal, make sure that the drain hole in the seal is in the 6 o'clock position.
Using the special tool, install a new extension housing seal.
2. NOTE: The output shaft and the driveshaft are a balanced assembly.
Install the driveshaft.
^
Align all the index marks and position the driveshaft on the transmission.
^
Install the driveshaft.