F 150 2WD V8-4.6L VIN W (2007)
6. Remove the driveshaft center bearing bolts and remove the driveshaft.
1. Remove the driveshaft center bearing bolts.
2. Lower the driveshaft and slide the driveshaft slip yoke rearward off of the output shaft.
^
To install, tighten to 48 Nm (35 ft. lbs.).
7. Plug the extension housing to prevent fluid loss.
8. CAUTION: The driveshaft flanges fits tightly on the pinion flange pilots. To make sure that the driveshaft flanges seat squarely on the pinion
flange pilots, tighten the driveshaft flange bolts evenly in a cross pattern.
CAUTION: If new bolts are not available, coat the threads of the original driveshaft flange bolts with Threadlock and Sealer.
NOTE: Align the index marks made during removal.
To install, reverse the removal procedure.
^
Install new driveshaft flange bolts.
Driveshaft Slip Yoke Boot
Driveshaft Slip Yoke Boot
Special Tools
Material
Removal
1. Remove the driveshaft.
2. CAUTION: Do not, under any circumstance, clamp the driveshaft in the jaws of a vise or similar holding fixture. Denting or localizing fracture
can result, causing driveshaft failure during vehicle operation.
Place the driveshaft on a suitable workbench. Do not damage the tubes.