F 150 2WD V8-4.6L VIN W (2007)
5. Remove the driveshaft from the special tool and install a new yellow snap ring.
6. CAUTION: Never mix yellow and black snap rings on opposing sides.
Repeat steps to install the new bearing cup and snap ring on the opposite side of the driveshaft slip yoke.
^
If the yellow snap ring will not seat in the snap ring groove, install the black snap rings.
7. CAUTION: Do not strike the bearings.
A sharp rap on the driveshaft yoke with a brass or plastic hammer will seat the bearing cups.
8. Rotate the driveshaft yoke to make sure the universal Joints are free to rotate easily, without binding, before installing the driveshaft.
9. Install the driveshaft.
