F 150 2WD V8-4.6L VIN W (2007)
1. Remove the rear trim panel pin-type retainers.
2. Remove the rear trim panel.
3. Remove the rear corner trim. For SuperCab vehicles, remove the B-pillar trim panel. For SuperCrew vehicles, remove the C-pillar trim panel.
4. CAUTION: The following substeps are to prevent the cables from popping out of the motor housing. If an existing regulator and motor
assembly is to be reused, do not allow the cables to pop out of the motor housing, as they can unwind from the drum. If the cables unwind
from the drum, a new regulator and motor assembly will have to be installed.
NOTE: LH side shown, RH side similar.
Remove the LH cable first, then the RH cable. Press and hold the transition block away from the centerline of the vehicle.
5. NOTE: LH side shown, RH side similar.
Clamp and hold the cable near the transition block.
