F 150 2WD V8-4.6L VIN W (2007)
4. CAUTION: The following substeps are to prevent the cables from popping out of the motor housing. If an existing regulator and motor
assembly is to be reused, do not allow the cables to pop out of the motor housing, as they can unwind from the drum. If the cables unwind
from the drum, a new regulator and motor assembly will have to be installed.
NOTE: LH side shown, RH side similar.
Install the LH cable first, then the RH cable. Install the cable swag into the guide bracket on the sliding rear window.
5. NOTE: LH side shown, RH side similar.
Compress and hold the cable tension spring.
6. NOTE: LH side shown, RH side similar.
Press the transition block away from the centerline of the vehicle, then snap it into the groove. Release the cable tension spring.