F 150 2WD V8-4.6L VIN W (2007)
Press and hold the inside edge of the roof ditch moulding away from the centerline of the vehicle.
6. NOTE: LH side shown, RH side similar.
Carefully twist the outside edge of the roof ditch moulding upward to release it from the outside edge of the Y-clip.
7. NOTE: LH side shown, RH side similar.
Push the outside edge of the moulding in toward the center of the vehicle and slide the moulding off the inside edge of the Y-clip.
8. Release the moulding from the remaining 3 Y-clips and remove the moulding.
9. NOTE: LH side shown, RH side similar.
Remove the Y-clips.
-
Starting with the bottom Y-clip, work upward toward the roof. Use light pressure to separate the A-pillar track near the Y-clip, then remove the
Y-clip.
