F 150 2WD V8-5.0L (2011)
2. Remove the 2 exhaust hanger bolts.
3. Remove the 2 heat shield screws.
4. Support the transmission with a suitable jack.
5. Remove the 2 transmission support nuts.
6. Remove the 4 transmission support crossmember nuts.
7. Remove the 4 transmission support crossmember support bolts.
8. Remove the transmission support crossmember.
Installation
1. Position the transmission support crossmember and install the
transmission support crossmember support nuts and bolts.
-
Tighten the nuts to 90 Nm (66 lb-ft).
2. Remove the transmission jack.
3. Install the 2 transmission support nuts.
-
Tighten to 103 Nm (76 lb-ft).
4. Install the exhaust hanger bolts.
-
Tighten to 40 Nm (30 lb-ft).
5. Install the 2 heat shield screws.
-
Tighten to 20 Nm (177 lb-in).