F 150 2WD V8-5.4L Flex Fuel (2008)
9. NOTE:
-
The inboard and outboard head restraint guides are not interchangeable.
-
If necessary, install new head restraint guides.
Access and remove the 2 head restraint guides.
-
Release the locking tabs and pull the head restraint guides out of the backrest frame tubes.
10. Remove the backrest trim cover.
Heated seat
11. Disconnect the backrest heater mat electrical connector.
12. CAUTION: If installing a new backrest foam pad, the heater mat cannot be reused. A new heater mat must be installed. Failure to follow
this instruction can result in component or system failure.
NOTE: A new heater mat can be attached to a foam pad where an old heater mat was removed but a used heater mat should not be reattached to
any foam pad.
To service the backrest heater mat, peel and remove from the backrest foam pad.
-
If reusing the backrest foam pad, take precautions not to remove excess foam when peeling off the heater mat. If the foam pad is damaged,
install a new foam pad and a new heater mat.
-
For installation, align and lay the heater mat flat on the foam pad surface without any wrinkles and correctly tuck into the valley of the foam
pad.
All seats
13. Remove the backrest foam pad.
14. Remove the bolt and the safety belt retractor.
-
To install, tighten to 35 Nm (26 lb-ft).
15. Remove the bolt and the safety belt tower bracket.
-
To install, tighten to 60 Nm (44 lb-ft).
16. Detach the lumbar assembly retainer clips.
