F 150 2WD V8-5.4L Flex Fuel (2008)
-
To install, tighten to 55 Nm (41 lb-ft).
-
The anti-rotation tab must be correctly aligned for correct installation.
-
When installing, pull the safety belt buckle through the anti-rattle strap located on the side of the seat.
14. If equipped, disconnect the backrest heater mat electrical connector.
15. If equipped with seat integrated restraints (SIR), remove the safety belt anchor nut.
-
To install, tighten to 55 Nm (41 lb-ft).
-
If passenger seat, disconnect the belt tension sensor (BTS) electrical connector.
16. If equipped, disconnect the power seat track electrical connector and release any pin-type retainers attached to the seat cushion frame.
17. If equipped, disconnect the 3 memory seat position sensor electrical connectors (one shown) and detach the wiring harness from the cushion frame.
18. If equipped with manual lumbar, release the rear inboard cushion trim cover J-clip and note the lumbar cable routing for installation.
19. Remove 4 nuts and cushion frame.
-
To install, tighten to 25 Nm (18 lb-ft).
-
Disconnect and detach all remaining electrical connectors and pin-type retainers attached to the seat cushion frame.
