F 150 2WD V8-5.4L Flex Fuel (2008)
-
When installing, install the bolts and tighten in the sequence shown.
-
To install, tighten to 30 Nm (22 lb-ft).
Driver seat
4. Remove the 2 nuts and seat position sensor.
-
Disconnect the seat position sensor electrical connector.
All seats
5. NOTE: Driver seat without seat integrated restraints (SIR) shown, others similar.
Remove the seat track control handle retaining clip.
6. NOTE: Driver seat without SIR shown, others similar.
Detach the seat track control handle and remove the outboard seat track.
7. NOTE: Driver seat without SIR shown, others similar.
Rotate the seat track adjust handle to relieve the spring tension and detach the seat track adjust handle from the inboard seat track.