F 150 2WD V8-5.4L Flex Fuel (2008)
Wheel Speed Sensor: Service and Repair
Front
Wheel Speed Sensor - Front, Rear Wheel Drive (RWD)
Wheel Speed Sensor - Front, Rear Wheel Drive (RWD)
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. NOTE: The harness connector is located in the engine compartment secured to the fender apron.
Disconnect the wheel speed sensor electrical connector.
3. Disconnect the 2 wheel speed sensor harness retainers from the brake hose.
4. Remove the wheel speed sensor harness from the pushpin retainer.
5. Remove the bolt and the wheel speed sensor.
^
To install, tighten to 8 Nm (71 lb-in).
6. To install, reverse the removal procedure.