F 150 2WD V8-5.4L Flex Fuel (2008)
1. If equipped with adjustable pedals, position them to the full forward position.
2. Remove the instrument panel steering column cover. For additional information, refer to Dash Board.
3. NOTE: The accelerator pedal and the brake pedal must be in the same position before connecting the adjustable accelerator pedal cable.
If equipped, disconnect the adjustable accelerator pedal cable from the accelerator pedal assembly and position it aside.
4. CAUTION: Do not service the brake pedal or brake booster without first removing the stop lamp switch and speed control deactivator
switch. These switches must be removed with the brake pedal in the at-rest position. Switch plungers must be compressed for the switch
to rotate in the bracket. Attempting to remove the switch when the plunger is extended (during pedal apply) will result in damage to the
switch.
If equipped, remove the speed control deactivator switch. For additional information, refer to Cruise Control.
5. Remove the stop lamp switch. For additional information, refer to Lighting and Horns.
6. If equipped with adjustable pedals, disconnect the adjustable pedal motor electrical connector at the top of the bracket.
7. Remove the 4 brake booster nuts.
^
To install, tighten to 25 Nm (18 lb-ft).
8. Remove the 2 upper brake pedal bracket bolts and the brake pedal and bracket assembly.
^
To install, tighten to 25 Nm (18 lb-ft).
9. CAUTION: Do not press, pull or otherwise move the brake pedal while installing the stop lamp switch or the speed control deactivator
switch. These switches must be installed with the booster push rod attached to the brake pedal and with the brake pedal in the at-rest
position. Installing these switches with the brake pedal in any other position will result in incorrect adjustment and may damage the
switches.
To install, reverse the removal procedure.
