F 150 2WD V8-5.4L Flex Fuel (2008)
Brake Master Cylinder: Service and Repair
Brake Fluid Reservoir
Brake Fluid Reservoir
Material
Removal and Installation
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of
serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety
Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash
it with water.
1. Using a suitable suction device, drain the brake fluid reservoir.
2. Disconnect the brake fluid level switch electrical connector.
3. Remove the 2 spiral pins from the master cylinder and the brake fluid reservoir.
4. Separate the brake fluid reservoir from the master cylinder.
5. To install, reverse the removal procedure.