F 150 2WD V8-5.4L Flex Fuel (2008)
Parking Brake - Exploded View (Part 2)
1. Relieve the parking brake cable tension.
2. Release the intermediate cable from the LH rear cable from the cable equalizer.
3. Remove and discard the double cable clamp.
4. Remove the RH parking brake bracket bolt.
^
To install, tighten to 30 Nm (22 lb-ft).
5. Disconnect the RH rear parking brake cable from the rear parking brake levers and remove the cable from the vehicle.
6. To install, reverse the removal procedure.
^
Inspect the parking brake system for correct operation.
Parking Brake Cable - Front
Parking Brake Cable - Front
Removal and Installation
Parking Brake Cable-Front
1. Release the tension on the parking brake cable.
2. Remove the LH cowl side trim panel. For additional information, refer to Trim Panel.
3. NOTE: The parking brake control take-up spool tab may need to be bent aside to allow the cable to be removed.
Disconnect the front parking brake cables from the parking brake control.