F 150 2WD V8-5.4L Flex Fuel (2008)
Hose/Line HVAC: Service and Repair
Condenser To Evaporator Line
CONDENSER TO EVAPORATOR LINE
Removal and Installation
1. Disconnect the battery.
2. Recover the refrigerant.
3. Remove the PCM.
4. Disconnect the A/C cycling switch electrical connector.
5. Remove the PCM bracket in the following sequence.
1
Remove the 3 PCM bracket bolts.
2
Remove the PCM bracket.
-
To install, tighten to 10 Nm (89 lb-in).
6. Disconnect the evaporator inlet fitting.
-
Discard the O-ring seals.
7. Disconnect the condenser outlet fitting.
-
Discard the O-ring seal.
-
To install, tighten to 25 Nm (18 lb-ft).
8. Remove the condenser to evaporator line.
9. To install, reverse the removal procedure.
-
Install new O-ring seals.