F 150 2WD V8-5.4L Flex Fuel (2008)
Crankshaft Position Sensor: Service and Repair
CRANKSHAFT POSITION (CKP) SENSOR
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Rotate the accessory drive belt clockwise and detach the accessory drive belt from the A/C compressor pulley.
3. Loosen the A/C compressor bolts enough to slide the A/C compressor down approximately 25 mm (1 in), to allow access to the crankshaft
position (CKP) sensor.
-
To install, tighten to 25 Nm (18 lb-ft).
4. Disconnect the CKP sensor electrical connector.