F 150 2WD V8-5.4L Flex Fuel (2008)
Part 2
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery.
3. Remove the nut and position the starter solenoid positive cable terminal aside.
-
To install, tighten to 12 Nm (9 lb-ft).
4. Remove the nut and position the starter solenoid wire terminal aside.
-
To install, tighten to 5 Nm (44 lb-in).
5. Remove the nut and position the starter motor ground cable terminal aside.
-
To install, tighten to 22 Nm (16 lb-ft).
6. Disconnect the battery cable harness locator on the RH engine mount.
7. Remove the nut and position the battery cable lower bracket aside.
-
To install, tighten to 10 Nm (89 lb-in).
8. Remove the bolt and position the battery ground cable frame terminal aside.
-
To install, tighten to 30 Nm (22 lb-ft).
9. Disconnect the battery cable harness locator from the radiator fan shroud.