F 150 2WD V8-5.4L Flex Fuel (2008)
2. If equipped, remove the front wheel speed sensor bolt and position the wheel speed sensor aside.
^
To install, tighten to 9 Nm (80 lb-in).
3. Remove and discard the outer tie-rod end nut and detach the tie-rod end from the wheel spindle.
^
To install, tighten to 150 Nm (111 lb-ft).
4. Remove and discard the upper ball joint nut, then detach the upper ball joint from the wheel spindle and remove the wheel spindle.
^
If necessary, remove the brake shield.
^
To install, tighten to 115 Nm (85 lb-ft).
5. Remove and discard the lower ball joint nut and detach the lower ball joint from the wheel spindle.
^
To install, tighten to 150 Nm (111 lb-ft).
6. To install, reverse the removal procedure.
7. Check and, if necessary, align the front end.
