F 150 2WD V8-5.4L Flex Fuel (2008)
10. Install the bolt for the RH heat shield to the transmission support crossmember.
^
Tighten to 20 Nm (15 lb-ft).
4WD vehicles
11. Install the transfer case.
RWD vehicles
12. NOTE: The output shaft and the driveshaft are a balanced assembly.
Install the driveshaft.
^
Align the yellow dots and position the driveshaft on the transmission.
13. NOTE: To maintain driveshaft balance, install the driveshaft yoke and flange in the original position that was marked during removal.
Install the 4 driveshaft bolts.
^
Tighten to 103 Nm (76 lb-ft).
