F 150 2WD V8-5.4L Flex Fuel (2008)
Vehicles equipped with 4.6/5.4L engines
7. If removed, position the selector lever cable bracket and install the 2 bolts.
^
Tighten to 25 Nm (18 lb-ft).
Vehicles equipped with 4.2L engines
8. Install the selector lever cable bracket.
1
Install the bolt.
^
Tighten to 40 Nm (30 lb-ft).
2
Install the nut.
^
Tighten to 40 Nm (30 lb-ft).
All vehicles
9. NOTE: The 4.6/5.4L shown, 4.2L similar.
NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the selector lever
cable end is snapped onto the ball stud. Press the selector lever cable into the bracket and listen for the selector lever cable to click in place. Pull
back on the selector lever cable to make sure that it is locked into the bracket. Also make sure that the selector lever cable end is correctly installed
onto the ball stud. Pull back on the selector lever cable end to make sure that the selector lever cable end is correctly installed.
Connect the selector lever cable to the selector lever cable bracket. Do not connect the selector lever cable to the manual control lever at this time.
10. Connect the electrical connector to the selector lever bracket.
