F 150 2WD V8-5.4L Flex Fuel (2008)
12. NOTE: LH side shown, RH side similar.
Remove the cable swag from the guide bracket on the sliding rear window.
Installation
All vehicles
1. NOTE: Remove as much of the foam core butyl as possible from the body and window glass prior to installation.
Apply foam core butyl to the window. Overlap the foam core butyl by 25 mm (1 in) at the bottom middle of the rear window glass.
Power sliding rear window
2. CAUTION: The following substeps are to prevent the cables from popping out of the motor housing. If an existing regulator and motor
assembly is to be reused, do not allow the cables to pop out of the motor housing, as they can unwind from the drum. If the cables unwind
from the drum, a new regulator and motor assembly will have to be installed.
NOTE:
-
The aid of an assistant will be required to support the glass in close proximity to the body opening during the following power sliding rear
window installation steps.
-
LH side shown, RH side similar. Install the LH cable first, then the RH side cable.
Install the cable swag into the guide bracket on the sliding rear window.
3. NOTE: LH side shown, RH side similar.
Compress and hold the cable tension spring.
