F 150 2WD Lightning V8-5.4L SOHC SC VIN 3 (2001)
13. Using the special tool, remove the crankshaft pulley.
Installation
1. NOTE: The crankshaft pulley must be installed within four minutes after applying the silicone.
Apply silicone gasket and sealant to the Woodruff key slot on the crankshaft pulley.
2. Using the special tool, install the crankshaft pulley.
3. Install the bolt and washer. Tighten the bolt in four stages.
^
Stage 1: Tighten to 90 Nm (66 ft. lbs.).
^
Stage 2: Loosen the bolt.
^
Stage 3: Tighten to 50 Nm (37 ft. lbs.).
^
Stage 4: Tighten an additional 85-90 degrees.