ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Engine Controls - DTC P1635 Set After PCM/IC Replacement|Page 3062 > < Exhaust System|Specifications
Page 1
background image

Technical Service Bulletin # 02-23-4

Date: 021125

Engine Controls - DTC P1635 Set After PCM/IC Replacement

Article No.
02-23-4

11/25/02

^

DIAGNOSTIC TROUBLE CODE (DTC) - P1635
AND/OR P1639 PRESENT AFTER POWERTRAIN
CONTROL MODULE (PCM) OR INSTRUMENT
CLUSTER REPLACEMENT - GASOLINE ENGINE
VEHICLES ONLY

^

LAMP - 4X4 LAMP ILLUMINATED AFTER
POWERTRAIN CONTROL MODULE (PCM) OR
INSTRUMENT CLUSTER REPLACEMENT - 
GASOLINE ENGINE VEHICLES ONLY

^

SPEEDOMETER - INACCURATE AND/OR
INOPERATIVE AFTER POWERTRAIN CONTROL
MODULE (PCM) OR INSTRUMENT CLUSTER
REPLACEMENT - GASOLINE ENGINE VEHICLES
ONLY

FORD:
1999-2002 MUSTANG
2000-2002 FOCUS
1999-2002 EXPEDITION, F-150
2000-2002 E SERIES
2001-2002 EXPLORER SPORT TRAC, EXPLORER SPORT, RANGER
2002 EXPLORER

LINCOLN:
1999-2002 TOWN CAR, NAVIGATOR
2002 BLACKWOOD

MERCURY:
2002 MOUNTAINEER

Article 02-5-8 is being republished in its entirety to update the Service Procedure and to clarify build dates for Explorer.

This article applies to all vehicles listed with the exception of 2002 Explorer. This article applies to 2002 Explorer (SLAP) St. Louis Assembly Plant
built before 3/11/2002 and 2002 Explorer (LAP) Louisville Assembly Plant built before 3/4/2002 only.

ISSUE

Some vehicles may exhibit an inoperative or inaccurate speedometer, 4x4 lamp illuminated, and/or Diagnostic Trouble Code (DTCs) P1635 or P1639
present after a Powertrain Control Module (PCM) or Instrument Cluster replacement. This may be caused by the Vehicle Identification (VID) block that
must be programmed when replacing the PCM.

ACTION

As part of the calibration, there is an area referred to as the Vehicle Identification (VID) block. The VID block must be programmed when replacing the
PCM. Failure to perform the proper Programmable Module Installation procedure may generate fault code: P1639 VID Block not programmed or is
corrupt--P1635 Tire/Axle Out Of Acceptable Range. Refer to the following procedures to ensure the PCM is properly configured.

OTHER APPLICABLE ARTICLES: NONE
SUPERSEDES:02-5-8
WARRANTY STATUS: INFORMATION ONLY
OASIS CODES: 204000, 204100, 206000, 690000, 698298

Engine Controls - DTC P1635 Set After PCM/IC Replacement|Page 3062 > < Exhaust System|Specifications