F 150 2WD Lightning V8-5.4L SOHC SC VIN 3 (2001)
2. -NOTE: The differential bearings need not be removed to overhaul the Ford limited slip differential. If bearing removal is required, use the 2-Jaw
Puller and the Step Plate.
NOTE: The anti-lock speed sensor ring cannot be reused once removed.
Remove the differential pinion shaft lock bolt, and remove the differential pinion shaft.
If required, remove the ring gear and anti-lock speed sensor ring.
3. Install the special tool in a suitable vise.
4. Install the differential case on the tool.
5. NOTE: Apply a small amount of grease to the centering hole of the special tool.
Install the special tool in the bottom side gear bore.
