F 150 2WD Lightning V8-5.4L SOHC SC VIN 3 (2001)
13. Using special tool, cut the urethane adhesive from the windshield glass.
^
Insert the blade into the urethane at the top middle and work toward the bottom corners.
CAUTION: Care must be taken to avoid scratching the pinch weld.
NOTE: Lubricate the urethane adhesive with water to aid Interior Auto Glass Cut-Out Knife Kit when cutting the urethane adhesive.
14. Using the special tool, distance the windshield from the body.
15. Using the special tool, cut the remaining urethane adhesive and remove the windshield glass.
NOTE: Removing the windshield glass may require more than one technician.
16. Using a soft brush or vacuum, remove any dirt and foreign material from the pinch weld.
INSTALLATION
CAUTION: After replacing the urethane installed glass, the vehicle should not be driven until the urethane has cured. The curing times at temperatures
above 13°C (55°F) and relative humidity above 50% is 12-24 hours (refer to Essex Drive Away Chart for cure times, as temperatures and humidity
vary). Inadequate curing of the urethane may adversely affect the strength of the urethane adhesive bond.
1. Dry fit the windshield glass by centering it side-to-side and by adjusting the setting blocks (if equipped) to get the correct position of the part
top-to-bottom. Make the alignment marks with tape or non-staining grease pencil on both the glass and the vehicle body.
