F 150 2WD Pickup V6-4.2L VIN 2 (1997)
EQUIPPED WITH 4.2L ENGINE
SERVICE KIT PART NUMBER: XU2Z-6020-AA
Front Cover Removal
1.
Install memory saver, then disconnect the battery negative cable.
2.
Raise and support the vehicle.
3.
Completely drain the radiator of coolant.
4.
Disconnect the knock sensor electrical connector. Route the wiring to the front of the engine.
5.
Disconnect the crankshaft position sensor electrical connector.
6.
Disconnect the oil pressure sender electrical connector.
7.
Lower the vehicle.
8.
Remove the jack handle.
9.
Remove the front air deflector.
10.
Remove the upper radiator hose.
11.
Remove the engine cooling fan and the fan shroud.
12.
Remove the drive belt.
13.
Disconnect the camshaft position sensor electrical connector.
14.
Detach the engine wiring harness pushpin from the water outlet tube flange.
15.
Route the front of the engine wiring harness away from the engine front cover.
16.
Disconnect the throttle position sensor electrical connector.
17.
Remove the vacuum line from the EGR valve.
