F 150 2WD Pickup V6-4.2L VIN 2 (1997)
Front Cover Installation
1.
Install the timing chain tensioner. Tighten the retaining bolts to 8-14 Nm (6-10 lb-ft).
2.
Make sure the balance shaft timing mark is at the 6 o'clock position. See Figure 7.
3.
Install the timing chain, crankshaft sprocket and camshaft sprocket as an assembly.
4.
Make sure the timing marks and the keyways are aligned. See Figure 8.
5.
Apply tension to the timing chain by removing the pick from the tensioner housing.
6.
Install the camshaft position sensor drive gear. Tighten the retaining bolt to 40-50 Nm (30-36 lb-ft).
7.
Position the new front cover gasket on the engine block.
8.
Apply Silicone Gasket and Sealant (F6AZ-19562-A) or equivalent to the exposed portion of the oil pan.
9.
Position the front cover assembly onto the engine block.
