F 150 2WD Pickup V6-4.2L VIN 2 (1997)
Ignition Switch Lock Cylinder: Service and Repair
Non-Functional
REMOVAL
1. Disconnect the battery ground cable.
2. Remove the steering wheel.
3. Twist off the cap from the ignition switch lock cylinder.
4. Remove the ignition switch lock cylinder.
^
Use a 3/8-inch diameter drill to drill down the middle of the ignition lock key slot until the ignition switch lock cylinder breaks loose.
^
Remove and discard the ignition switch lock cylinder and drill shavings from the steering column.
5. Remove the bearing retainer.
6. Remove the bearing and the gear.