F 150 2WD Pickup V6-4.2L VIN 2 (1997)
5. Press the dust slinger off the coupling shaft.
ASSEMBLY
1. Install the driveshaft center bearing support.
(1) Install the dust slinger.
(2) Install the driveshaft center bearing bracket on the rubber insulator.
(3) Use a suitable press to press) the bearing onto the driveshaft.
(4) Install the bearing retainer.
NOTE: The driveshaft center bearing bracket must be installed with the deep flange rearward.
2. Slide the small opening end of the (A) driveshaft slip yoke boot on the (B) splined stub shaft as far as it will travel.
3. Install the driveshaft slip yoke boot clamp and use Keystone Clamp Pliers to crimp the driveshaft slip yoke boot clamp.
4. Install the driveshaft slip yoke.
(1) Lubricate the stub shaft splines and pull the differential slip yoke boot towards the driveshaft.
-
Use Premium Long-Life Grease XG-1-C or-K or equivalent meeting Ford specification ESA-M1C75-B.
(2) Fill the differential slip yoke boot with approximately 10 grams of lubricant.
