F 150 2WD Pickup V6-4.2L VIN 2 (1997)
8. If the vibration is still evident, rotate the clamps away from each other until balanced and test.
9. If necessary, continue to rotate the clamps apart in smaller increments and test. If the vibration still exists, repeat the procedure at the front of the
driveshaft.
10. Install the tire and wheel assembly.
(1) Position the tire and wheel assembly.
(2) Install the lug nuts.
(3) Lower the vehicle and tighten the lug nuts.
(4) Install the center cap.
11. Road test the vehicle.
NOTE: If equipped with air suspension, reactivate the system by turning on the air suspension switch.
