F 150 2WD Pickup V8-351 5.8L (1986)
Anti-Rattle Clip Position
2. Position the inner pad and anti-rattle clip in the pad abutment with the anti-rattle clip tab against the pad abutment and the loop-type spring away
from the rotor. Compress the anti-rattle clip and slide the upper end of the pad in position.
3. Install the outer pad. Crimp or bend outer pad tabs to prevent pads from rattling in caliper.
4. Install caliper on the spindle. Make sure the mounting surfaces are free of dirt and lubricate the caliper grooves with disc brake caliper grease.
Caliper Pin Installation
5. Position pin with the pin retention tabs oriented adjacent to the spindle groove.
NOTE: Do not use the bolt and nut with the new pin.
6. Tap the pin on the outboard end with a hammer. Continue tapping the pin inward until the retention tabs on the sides of the pin contact the spindle
face. Repeat procedure for the lower pin.
Correct Caliper Pin Installation
CAUTION: During the installation procedure do not allow the tabs of the caliper pin to be tapped too far into the spindle groove. If this happens
