F 150 2WD Pickup V8-4.6L (2002)
10. Apply a bead of Urethane Adhesive Essex 400 HV or Essex U-216 meeting Ford specification WSB-M2G316-B to the pinch weld just outside the
foam dam.
CAUTION: If a vehicle is to be driven within 24 hours of urethane adhesive application, Urethane Adhesive Essex U-216 meeting Ford
specification WSB-M2C316-B must be used due to its one hour cure time.
11. Install the interior rear view mirror.
12. Using the alignment marks, install the windshield glass.
CAUTION: Open the windows to prevent the windshield glass from being pushed out by air pressure if a door is closed.
13. Check the installation for air and water leaks through the urethane bond and add urethane adhesive where needed.
14. Install the upper windshield weatherstrip.
15. Paddle the excess urethane adhesive from the two sides of the windshield glass.
NOTE: Use one continuous stroke when removing the excess urethane adhesive.
16. If necessary, remove excess urethane adhesive from the outside surface of the windshield glass.
